Flame Sensor Module
Flame Sensor Module
Specifications
- Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm
- Detection angle about 60 degrees, it is sensitive to the flame spectrum.
- Accuracy adjustable
- Operating voltage 3.3V ~ 5V
- Output: Analog voltage output and Digital switch outputs (0 and 1)
- With a mounting screw hole
- Power indicator (red) and digital switch output indicator (green)
- Comparator chip LM393, it is stable
- Flame detection distance, lighter flame test can be triggered within 0.8m, if the intensity of flame is high, the detection distance will be increased
- Fixed Hole Diameter: 3mm
- Size: 3.2 x 1.9cm
Interface(4-wire):
- VCC: 3.3V ~ 5V
- GND: Ground
- DO: board digital output interface (0 and 1)
- AO: board analog output interface
Security policy
Delivery policy
Return policy
IR Infrared 4 Wire Flame Detection Sensor Module IR Flame Sensor Module Detector Smart sense For Arduino
Great Sensors for Arduino Project. Having Fun With Electronics and Programming!
This module can detect flame or light source with wavelength ranging from 760 nanometers to 1100 nanometers.
Adjustable sensitivity (adjust by the blue digital potentiometer adjustment)
Comparator output with clean signal, good waveform and more than 15mA strong driving ability.
Output format: DO digital switching outputs (0 and 1) and AO analog voltage output